I couldn’t resist, I’m sorry… Not.
Mouse is, obviously, a greyhound, which is a sighthound breed. One of the results of this is that his head is very long and narrow and his neck is wider and muscular. A regular dog collar doesn’t work so well, because he can reverse right out of it and prance off at speed, sneering at us for being so slow. Yes, that’s experience talking… Consequently, he wears a martingale collar. This is a collar with a second loop as part of its circumference, which extends and tightens when it’s pulled, thereby closing the collar up. There is a limit on how tight it can go, you don’t want to garrotte your beloved doggo, but at the same time, you don’t want him getting loose and into danger. Most of the time, it’s comfortably loose, so that you can get at least two or three fingers inside it.
Mouse wears a Greenhound Collar, which in addition to being a martingale collar, indicates that he’s been through some fairly extensive training to be socialised and safe around adults, children, other dogs and other animals. It has a registration number so that he can be identified, and wearing it permits him to be off-leash without a muzzle in designated off-leash dog areas such as dog parks. However, he’s been wearing it more or less non-stop since we got him, and it’s now seriously grubby.
So I did.
I ordered some rather gorgeous woven smooth webbing online, and some titanium-rainbow effect hardware to match. Locally, I bought wide black webbing intended for bag-straps, and a pair of black square ‘rings’. The original hardware set was intended for bag making and did not contain the necessary additional rings, hence the extra purchase.
I measured his adjustable Greenhound Collar. Because this new one’s custom, I didn’t need to make it adjustable, and used the fitted, finished sizes. I subtracted length for the buckle, and added back in the fold-over at each side of the buckle and both sides at the front. I cut both lots of webbing to size and sealed the ends by rapidly passing them through a lighter flame (Be careful not to touch the sealed ends too quickly. Ask me how I know this…).
The assembly order is important. Assemble the bits either side of the buckle first. Then add the square rings at the outer ends. Then feed the two ends of the front loop through the square rings. Stitch the smaller webbing to the wider webbing, and stitch down the fold-overs for the hardware. Close up the loop at the front, ensuring you create a free section in the overlap to contain the D ring at the centre front. Stitch all fold-overs with a square/X seam, and the overlap at the front with close zigzag to seal down the free ends. I used a thread that co-ordinated with and enhanced the colourful pattern on the narrower webbing.
To match, I made him a lead, also with the ‘titanium’ hardware and using the same colourful webbing. It isn’t quite as sturdy as the the thick woven cotton Greenhound set, but since it’s not designed for daily walkies but for swanking about in, I’m not concerned.
To finish the whole thing off, we’ve got him an engraved tag. The front has his name and my phone number (retouched out for privacy), and his local government registration and Greenhound numbers on the back. Black with silver engraving. Looks good with the rest of it, don’t you think?
He’s currently getting used to it. The Greenhound collar is going to take a while to dry, it’s very thick, and meanwhile, the swanky collar is a bit heavier due to the buckle, and makes a different noise. He’s shown no signs of wanting to get rid of it, which is a start!
But he deserves it.
*Just wait till you see what I have in mind for Halloween….